EUROBLOC
SERVICE MANUAL FOR HOIST
66/212
This document and the information contained herein, is the exclusive property of Verlinde S.A.S. and represents a non-public, confidential and proprietary trade secret that
may not be reproduced, disclosed to third parties, altered or otherwise employed in any manner whatsoever without the express written consent of Verlinde S.A.S.
Copyright © (2013) Verlinde S.A.S. All rights reserved.
06/2015
Disassembly
1
2
Lower hook to the floor and switch OFF the power supply to
the hoist. Remove the machinery covers.
Remove the guide bearings (3) on the rope guide.
Remove one intermediate shaft (1) from the hoisting unit. It is
recommended to remove the shaft that is at the top corner,
opposite to the side where the rope leaves the drum.
3
4
Remove the rope exit gate (4) and screws (6)
Remove the rope guide tension screws (7). When the screws
are off, remove the springs (8) and the spacers (5).
5
Remove the rear half of the rope guide (10) and then the front
half of the rope guide (9).
