EUROBLOC
SERVICE MANUAL FOR HOIST
51/212
This document and the information contained herein, is the exclusive property of Verlinde S.A.S. and represents a non-public, confidential and proprietary trade secret that
may not be reproduced, disclosed to third parties, altered or otherwise employed in any manner whatsoever without the express written consent of Verlinde S.A.S.
Copyright © (2013) Verlinde S.A.S. All rights reserved.
06/2015
Reassembly
1
Place the sleeve (11) at the base of the hoist axle. Apply
silicone adhesive on the seal plate and end plate joint and on
the sleeve.
2a
2b
Use the lifting device (A) to install the gearbox. Align the
gearbox axle carefully on the gear rim (B).
Check the alignment of the holes and correct the alignment by
using metal rods (C), if necessary
3a
3b
Place the connecting plate (8) with the help of the metal rods.
Place the shim plate (9) under the connecting plate (8) and
fasten the gear to its place by using the mounting screws.
Fasten also the mounting screws to the left side (A) of the
gear.
Install the two dowel pins (10) top and bottom corners of the
connecting plate.
