EUROBLOC
SERVICE MANUAL FOR HOIST
204/212
This document and the information contained herein, is the exclusive property of Verlinde S.A.S. and represents a non-public, confidential and proprietary trade secret that
may not be reproduced, disclosed to third parties, altered or otherwise employed in any manner whatsoever without the express written consent of Verlinde S.A.S.
Copyright © (2013) Verlinde S.A.S. All rights reserved.
06/2015
7.4
Electrics
7.4.1 Push-button controller
The hoisting and travel motions of the hoist as well as crane travel motions are controlled with the push-button
controller or by remote control. Some push-button controllers and remote control units are provided with a selector
switch that allows the same controller unit to be used to control several hoists and/or cranes.
c_hopbnw1b
1. Movement push-buttons
2. Hoist selection push-button (only if push-button controls several hoists)
3. Push-button ON and warning signal
4. Emergency stop push button
5. Display (optional)
Use the following procedure to start up a hoist that is in standby mode:
Release the emergency stop push-button by turning it. Use a key to release if it is the lockable type.
Press the push-button ON. The hoist is now ready for operation.
Note: If the push-button controller includes a selection switch, check that the hoist selection switch is in the
correct position before using push-buttons.
After operating the hoist, return it to standby mode as follows:
Run the hoist to the correct parking position. Stop all hoist motions.
When all hoist motions have ceased, press the emergency stop push-button. The push-button locks.
