USB 2.0 Interface:
USB 2.0 interface is used to connecting peripheral equipment.
Management Port:
Designed to connect to the device with a bandwidth of 10Mbps,
100Mbps or 1000Mbps. It has a corresponding MGMT LED on the front panel. You need
assign an IP address for the port to manage the switch.
RJ-45 Console Port:
Designed to connect with the serial port of a computer or terminal for
monitoring and configuring the switch. The switch has an RJ-45 console port and a
micro-USB console port available. Console input is active on only one console port at a time.
By default, the micro-USB connector takes precedence over the RJ-45 connector.
Power Supply Module 1/2:
One AC Power Supply Module PSM150-AC has been installed in
the switch. The malfunctioned PSM150-AC can be replaced with a TP-Link power supply
module of the same model. Its input voltage is 100-240V~ 50/60Hz.
The AC Power Supply Module is fully hot swappable, helping to ensure no system
interruption during installation or replacement. For how to install/remove the Power Supply
Module, please refer to
Installation Guide
.
With all the protective covers removed, and the Interface Card (TX432) & Power Supply Module
(PSM150-AC) inserted, the rear panel of T3700G-28TQ/T3700G-52TQ is shown as the
following figure.
Power
PS OK
Fault
PSM150-AC
100-240V~ 50/60Hz 2.5A
Power
PS OK
Fault
PSM150-AC
100-240V~ 50/60Hz 2.5A
M1
SFP+
M2
SFP+
CLASS 1LASER PRODUCT
TX432
Figure 2-5
Rear Panel (2) of T3700G-28TQ
Figure 2-6 Rear Panel (2) of T3700G-52TQ
11
