Tektronix RSA6100A Series, Help Manual

Page: 225 / 415

Pulsed RF > Common Controls for Pulsed RF Displays Pulsed RF Shared Measurement Settings
Pulsed RF Shared Measurement Settings
The control panel tabs in this section are shared by the displays in the Pulsed RF folder (Setup > Displays).
Changing a setting on one tab changes that setting for all the Pulsed RF displays.
Common controls for pulsed RF displays
Settings tab Description
Params (see page 212) Speci fi es several parameters that control how pulses are counted and de fi ned.
De fi ne (see page 214) Speci fi es parameters that control where measurements are taken on a pulse.
Levels (see page 219) Speci fi es parameters that control the method and levels used to calculate some pulse
values.
Freq Estimation (see
page 220) Speci fi es the reference used for computing frequency errors.
Scale (see page 221) Speci fi es the vertical and horizontal scale settings.
Prefs (see page 222) Speci fi es whether or not certain elements of the display are shown.
xxx
Params Tab
The Params tab enables you to adjust several measurement parameters for Pulsed RF displays.
Setting Description
Measurement Filter Specify whether a fi lter is used to limit the bandwidth of the input signal.
Bandwidth Sets the bandwidth of the measurement fi lter.
Power threshold to detect
pulses Speci fi es the level used for locating pulses in the data.
Minimum OFF time between
pulses Speci fi es the time the signal must fall below the power threshold for two pulses to be
considered separate pulses.
Max number of pulses Speci fi es the number of pulses to measure within the analysis time.
xxx
RSA6100A Series Real-Time Spectrum Analyzers Help
213