Tektronix RSA6100A Series, Help Manual

Page: 159 / 415

RF Measurements > MCPR Channels Tab for MCPR
Setting Description
Main Channels
Number
Sets the number of Main channels.
BW Sets the bandwidth of the Main channels.
Spacing Sets the frequency difference between the centers of the Main channels.
Inactive
Selected channels are ignored by the measurement routine.
Adj Chans
Add...
Opens the Edit Channel Parameters dialog, which you use to specify the parameters of a
new pair of adjacent channels. You can add up to 50 adjacent channel pairs.
Edit...
Opens the Edit Channel Parameters dialog box. (You must fi rst select a channel to
enable the Edit button.)
Delete Deletes the selected main channel or adjacent channel pair.
Add Adj.
Add a new pair of adjacent channels at the bottom. Their parameters are copied from
the channels just above them.
Channel De fi nition table A table of the parameters for every channel. Offset is the frequency difference between
the Center Frequency and center of the selected channel. Nothing in the table is editable
directly.
xxx
The following
fi gure illustrates the settings controlled from the Channels tab.
Editing Channel Parameters
To edit the offset or bandwidth of a Main channel:
1. Select the value in the BW or Spacing number entry boxes.
2. Adjust the value as required. All the Main channels share the same BW and Spacing.
3. Select the appropriate check box to make a channel Inactive, as appropriate.
4. Select the Close box when you have fi nished making changes.
RSA6100A Series Real-Time Spectrum Analyzers Help
147