Tektronix RSA6100A Series, Help Manual

Page: 384 / 415

Reference > Troubleshooting Error and Information Messages
RBW con fl ict. Increase Span or Analysis Length
The measurement is not running because the actual RBW used by the measurement is too large for the
current acquisition span. Typically, the analysis length is too short as well.
Either increase the span or increase the Analysis Length.
RBW decreased
The current span or acquisition bandwidth is too small to allow a wider RBW fi lter.
Increase the span or acquisition bandwidth if the decreased RBW is not acceptable.
RBW increased
The current Spectrum Length (or Analysis Length if Spectrum Length is not Independent) is too small
to allow the requested RBW.
Increase the Spectrum Length (or Analysis Length) if the increased RBW is not acceptable.
RBW limited by AcqBW to: XX Hz
The requested RBW is too close to the acquisition BW. Increase the frequency range of the measurement
(for example, Span).
RBW too small/large for current Acq BW
If the RBW is set manually, it is possible for the acquisition bandwidth to be incompatible with the
RBW setting.
Change the RBW setting.
Adjust the Acq BW setting, either directly (Setup > Acquire > Sampling Params: select on of the
manual modes) or by adjusting the measurement bandwidth of the selected display (Setup > Acquire >
Sampling Params: All Auto).
Recall error: Setup not completely restored
An error occurred while recalling a Setup fi le. Thus, the current setup may be a combination of settings
from the Setup fi le and the previous Setup.
Recall the setup again.
Recall failure: problem with fi le or fi le contents
An error occurred while recalling a Setup, Trace or Data fi le. This can occur because of a problem opening
the fi le (operating system error) or because of a problem with the contents of the fi le.
Recall the fi le again.
Restoring acquisition data...
This is a status message displayed while data is being restored from a fi le.
RF ADC overrange
This input signal power is outside the range of the analog-to-digital converter circuitry.
Decrease the input signal power or increase the internal attenuation setting.
372
RSA6100A Series Real-Time Spectrum Analyzers Help