Tektronix RSA6100A Series, Help Manual

Page: 183 / 415

RF Measurements > Phase Noise Phase Noise Display
Item Display element Description
1
Check Mark Indicator Indicates the display for which the acquisition hardware is optimized.
2
Vert Position (dBc/Hz) Sets the top of graph value. This is only a visual control for panning the graph.
3 Trace selector
Selects a trace.
4 Show check box Shows/hides the selected trace.
5 Detection method / Average
count Displays the Detector method used for the trace. If Average detection is
enabled, the number of averaged traces appears here.
6 Measurement Marker readout
Readout of the value of the phase noise at the selected offset. The Phase
Noise measurement marker does not affect the results reported in the
readouts or table below the graph, nor is it associated with markers in any
other display.
7 Clear Restarts multi-trace function (Average).
8 Horizontal stop Readout of the Right Horizontal frequency value. This setting affects only
visual scale, not measurement bandwidth. (See
Settings > Scale (see
page 122) )
9 Measurement marker Indicates the position of the measurement point.
10
Integration frequency range
indicators The gray-shaded areas denote the frequencies outside the integration
frequency range. (See Settings >
Frequency (see page 298) )
11 Phase Noise Table Displays the phase noise values at different offsets.
12 Horizontal start Readout of the Left Horizontal frequency value. Affects only visual scaling,
not measurement bandwidth. (See
Settings > Scale (see page 122) )
13 Measurement results
readouts Display of the different measured values.
xxx
Elements of the Measurement Results Readout / Phase Noise Table
RSA6100A Series Real-Time Spectrum Analyzers Help
171