![background image](http://html1.mh-extra.com/html/tektronix/59021-10/59021-10_user-manual_1078414028.webp)
Getting Started
DG2040 Data Generator
1Ć9
CAUTION.
The instrument is shipped with a power cord appropriate for use with
your power systems (normal 115 V power system or 230 V power system). If the
instrument is to be used with a power system other than what the order specified,
the power cord must be replaced with one appropriate for the power source
used.
Apply power to the standby circuit of the instrument by pushing the
PRINCIPAL POWER SWITCH on the rear panel of the instrument. Refer to
Figure 1-1.
NOTE
. After the instrument is installed, leave the PRINCIPAL POWER
SWITCH on and use the ON/STBY switch as the power switch.
Fuse
PRINCIPAL POWER
SWITCH
Power Connector
Figure 1Ć1: Rear panel power switch, fuse holder, and connector
Press the ON/STBY switch on the lower left side of the front panel to power on
the instrument. Refer to Figure 1-2.
After power on, verify that the fan is operating.
Standby Power
Power On
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com