Operating Basics
2Ć30
DG2040 Data Generator
Figure 2Ć22: Binary pattern creation
Follow the steps below to save the created data on the 3.5 inch floppy disk.
5. Insert a blank IBM-formatted 3.5 inch floppy disk in the drive.
6. Name the new file COUNT1.
Menubutton
Bottom button
PopĆup menu
Side button
FrontĆpanel
button
File
Save Data &
Setup
Clear String
COUNT1
*
OK
* Select each character in the file name using the generalĆpurpose knob and the
up and down arrow buttons. Press the EXECUTE button to insert the character
in the file name.
The data in this procedure is saved in the file named COUNT1.PDA.
Tutorial 2 loads a file from a 3.5 inch floppy disk and demonstrates pattern
editing using that data.
Before loading a file from the 3.5 inch floppy disk, initialize the instrument’s
data and settings. This allows you to see the effect of loading the file you
previously saved in Tutorial 1.
Tutorial 2: Loading and
Editing a Pattern
Stored in a File
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com