![background image](http://html1.mh-extra.com/html/tektronix/59021-10/59021-10_user-manual_1078414033.webp)
Operating Basics
2Ć2
DG2040 Data Generator
Controls, Connectors, and Display
Figure 2-1 Shows the locations of the front panel controls and connectors.
See Figure 2-1 on page 2Ć3
Bottom and side
bezel buttons
ON/STBY Button
CLEAR MENU Button
This button is used as the
power switch in normal
operation. The
PRINCIPAL
POWER SWITCH
on the rear
panel must be on.
Output Connectors
The CH 0 to CH 1 SMA connectors output pattern
data with variable output level in the range
-1.125 V to +3.50 V into 50
W
. The delay times
for each channel can be varied from -1.0 ns to
+1.0 ns. If you use only one output connector for
each channel, you must terminate the other
connector using an SMA termination.
Cancels the current operation
and closes side and submenus.
The display can be returned to
the top level by repeatedly
pressing on the CLEAR MENU
button.
The main use of the bottom buttons is
to call up sub menus, and the side
buttons are used to execute more
detailed operations within the sub
menus.
1.1 Gbps
Figure 2Ć1: Front panel controls
CAUTION.
If external voltages are applied to the data output connectors, be sure
to set the high-impedance control correctly. Signal collisions may result in
output currents or voltages in excess of the rated values.
Front Panel
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com