Suzuki Liana RH418, Supplementary Service Manual

Page: 245 / 371

Automatic Transmission/Transaxle: 5A-19
Scan Tool Data
S3RH0B5104009
As the data values given in the following table are standard values estimated on the basis of values obtained from the
normally operating vehicles by using a scan tool, use them as reference values. Even when the vehicle is in good
condition, there may be cases where the checked value does not fall within each specified data range. Therefore,
judgment as abnormal should not be made by checking with these data alone.
Also, condition in the following table that can be checked by the scan tool are those detected by TCM and output from
TCM as commands and there may be cases where the automatic transaxle or actuator is not operating (in the
condition) as indicated by the scan tool.
NOTE
The following scan tool data related to automatic transaxle can be checked only by communicating
with TCM.
Scan tool data Vehicle condition
Normal condition / reference
values
) GEAR POSITION Ignition switch ON
Selector lever is in “P” position P or N
Selector lever is in “R” position R
Selector lever is in “N” position P or N
Selector lever is in “D” position 1st
Selector lever is in “2” position 1st
Selector lever is in “L” position 1st
) ENGINE SPEED At engine idle speed Engine idle speed is displayed
) INPUT SHAFT REV
At engine idle speed and selector lever is in “P”
position (Engine idle speed is displayed in
increments of 50 rpm)
At 60 km/h (37.5 mile/h) constant speed, O/D off
switch ON, 20% or less throttle opening and 3rd gear
(“D” range)
2150 RPM
(displayed in increments of 50 rpm)
) OUTPUT SHAFT
REV
At vehicle stop 0 RPM
At 60 km/h (37.5 mile/h) constant speed, O/D off
switch ON, 20% or less throttle opening and 3rd gear 2150 RPM
(displayed in increments of 50 rpm)
) BATTERY VOLT. Ignition switch ON and engine stop 9 – 16 V
) ATF TEMP.
After driving at 60 km/h (37.5 mile/h) for 15 minutes or
more, and A/T fluid temperature reaches 70 – 80
°
C
(158 – 176
°
F)
70 – 80
°
C (158 – 176
°
F)
) SHIFT SOL #1
COM: *** MON:***
Within 3 seconds after shifting “D” to “P” ON
At 40 km/h (25 mile/h) constant speed, O/D off switch
ON, 20% or less throttle opening and 3rd gear
OFF
) SHIFT SOL #2
COM: *** MON:***
Within 3 seconds after shifting “P” to “D” ON
At 40 km/h (25 mile/h) constant speed, O/D off switch
ON, 20% or less throttle opening and 3rd gear
ON
) TCC SOL COM: ***
MON:***
At 5 km/h (3 mile/h) constant speed, O/D off switch
OFF, closed throttle and 1st gear
OFF
At 80 km/h (50 mile/h) constant speed, O/D off switch
OFF, 20% or less throttle opening and 4th gear
ON
) PRESS CONT SOL At vehicle stop, closed throttle and 1st gear 9.5%
) VEHICLE SPEED At vehicle stop 0 KM/H, 0 MPH
) O/D OFF SWITCH
(MON)
Ignition switch ON
O/D off switch OFF OFF
O/D off switch ON ON
) TRANS. RANGE Ignition switch ON
Selector lever is in “P” position P
Selector lever is in “R” position R
Selector lever is in “N” position N
Selector lever is in “D” position D
Selector lever is in “2” position 2
Selector lever is in “L” position L