Suzuki Liana RH418, Supplementary Service Manual

Page: 338 / 371

5A-112 Automatic Transmission/Transaxle:
3) Remove angular ball bearing from counter drive
gear.
NOTE
If inner race of angular ball bearing remains
on counter drive gear (1), remove it using
gear puller and special tools.
Special tool
(A): 09925-86010
(B): 09925-06010
Reassembly
1) Press new angular ball bearing (1) into counter drive
gear (2) using special tool.
Special tool
(A): 09951-46010
2) Temporally tighten new lock nut.
3) Clamp special tool in vise (1) and place counter drive
gear onto the special tool.
Special tool
(B): 09927-76040
4) Tighten new lock nut using special tool until starting /
rotation torque (bearing preload) will be in specified
value shown in the following.
Special tool
(A): 09927-26010
Counter drive gear bearing preload
Starting torque: 0.05 – 0.25 N
⋅
m (0.005 – 0.025
kgf-m, 0.037 – 0.180 lb-ft)
Rotational torque: 0.05 – 0.15 N
⋅
m (0.005 – 0.015
kgf-m, 0.037 – 0.108 lb-ft)
5) Stake new lock nut, using standard punch in
combination with hammer.
NOTE
When staking lock nut, point a suitable
staking tool (1) toward axis center shaft (3)
and stake lock nut (2) securely as shown in
figure. (Poor staking may cause abnormal
noise.)
I2RH01510202-01
I2RH01510203-01
I2RH01510204-01
[A]: Correct [B]: Wrong [C]: Wrong
I2RH01510205-01
I3RH0B510034-01