Suzuki Liana RH418, Supplementary Service Manual

Page: 336 / 371

5A-110 Automatic Transmission/Transaxle:
17) Install input shaft to reverse clutch drum.
18) Install sun gear input flange (1) with retainer ring (3).
19) Apply A/T fluid to thrust washer.
20) Install thrust washer (2) to reverse clutch assembly.
21) Apply A/T fluid to input shaft front thrust roller
bearing and race.
22) Install thrust needle roller bearing and race (1) to
reverse clutch assembly (2).
Input shaft front thrust roller bearing dimension
Outside diameter: 33.1 mm (1.30 in.)
Inside diameter: 18.6 mm (0.73 in.)
Thickness: 3.4 mm (0.13 in.)
Input shaft front thrust roller bearing race
dimension
Outside diameter: 34.4 mm (1.35 in.)
Inside diameter: 21.5 mm (0.85 in.)
Thickness: 0.8 mm (0.03 in.)
Reverse Clutch Inspection
S3RH0B5106047
1) Check that sliding surfaces of friction, separator and
cushion plates are not worn or burnt. If necessary,
replace.
NOTE
• If friction plate lining is exfoliated,
discolored or worn hardly, replace all
friction plates.
• Before assembling new friction plates,
soak them in A/T fluid for at least two
hours.
2) Measure height of reverse clutch return spring.
Reverse clutch return spring height
Standard: 18.7 mm (0.74 in.)
NOTE
Do not apply excessive force when
measuring spring height. Perform
measurement at several points.
I2RH01510184-01
I2RH01510194-01
I2RH01510195-01
I2RH01510196-01