Suzuki Liana RH418, Supplementary Service Manual

Page: 352 / 371

5A-126 Automatic Transmission/Transaxle:
33) Temporarily tighten transaxle housing to transaxle
case with 5 – 6 bolts.
34) Stand transaxle up (i.e.: transaxle housing facing
down-ward).
35) Install front and rear planetary carrier (1) while
rotating counter-clockwise and clockwise.
36) Install sun gear (2) with sun gear thrust roller bearing
(3).
Sun gear thrust roller bearing dimension
Outside diameter: 32.5 mm (1.28 in.)
Inside diameter: 18.8 mm (0.74 in.)
Thickness: 2.7 mm (0.11 in.)
37) Apply A/T fluid to carrier rear thrust roller bearing
race (4).
38) Install carrier rear thrust roller bearing race (4) to
planetary carrier.
39) Install overdrive / coast clutch assembly (1) while
rotating counterclockwise and clockwise.
NOTE
Make sure that overdrive / coast clutch
assembly locks when turned
counterclockwise [A] and moves freely when
turned clockwise [B].
40) Install forward clutch assembly while rotating.
41) Check for correct installation of each component
parts as follows.
Measure the distance “a” by using vernier (1) and
straightedge (2). If out of specification, remove
forward clutch, overdrive / coast clutch, front and
rear planetary carrier and reinstall them properly.
Distance between forward clutch drum (3) and
mating surface of transaxle case
“a”: 46.94 – 47.81 mm (1.848 – 1.882 in.)
42) Apply sealant to mating surface of transaxle case by
using a nozzle (2) as shown in figure by such
amount that its section is 1.5 mm (0.059 in) in
diameter.
“A”: Sealant 99000–31230
I2RH01510245-01
I2RH01510246-01
I2RH01510247-01
I2RH01510248-01