Suzuki Liana RH418, Supplementary Service Manual

Page: 306 / 371

5A-80 Automatic Transmission/Transaxle:
Remounting
1) Make sure that torque converter is installed correctly
to transaxle.
Refer to “Automatic Transaxle Unit Assembly”.
2) Attach transaxle to engine.
Tightening torque
Transaxle to engine bolts and nut (a): 85 N·m (
8.5 kgf-m, 61.5 lb-ft)
WARNING
!
Be sure to keep transaxle with torque
converter horizontal or facing up throughout
the work. Should it be tilted with torque
converter down, converter may fall off and
cause personal injury.
3) Tighten drive plate-torque converter bolts.
Align drive plate bolt hole and torque converter
through then tighten bolts through torque converter
housing lower plate opening.
Lock drive plate (1) by engaging a flat head rod or
the like (2) with drive plate gear.
Tightening torque
Drive plate to torque converter bolt (a): 25 N·m (
2.5 kgf-m, 18.0 lb-ft)
4) Install lower stiffener.
Tightening torque
Lower stiffener bolt: 50 N·m (5.0 kgf-m, 36.5 lb-
ft)
5) Install starter motor.
Tightening torque
Starter motor bolt: 23 N·m (2.3 kgf-m, 16.5 lb-ft)
6) Install center shaft (1) to differential gear. Tighten
center bearing support bolts to specified torque.
Tightening torque
Center bearing support bolt (a): 55 N·m (5.5 kgf-
m, 40.0 lb-ft)
7) Install engine rear mounting brackets and stiffener.
8) Remount engine with transaxle assembly to vehicle.
Refer to “Engine Assembly Removal and Installation
in Section 1D” for its procedure.
3. Wrench
(a)
(a)
I2RH01510092-01
1
(a)
2
3
I2RH01510093-01
(a)
1
I2RH01510094-01