5A-36 Automatic Transmission/Transaxle:
DTC Troubleshooting
Table for Step 4
Step
Action
Yes
No
1
Was “A/T System Check” performed?
Go to Step 2.
Go to “A/T System
Check”.
2
Do you have SUZUKI scan tool?
Go to Step 3.
Go to Step 4.
3
Check transmission range sensor (switch) circuit for
operation.
Check by using SUZUKI scan tool:
1) Connect SUZUKI scan tool to DLC with ignition switch
OFF.
2) Turn ignition switch ON and check transmission range
signal (“P”, “R”, “N”, “D”, “2” or “L”) on display when
shifting select lever to each range.
Is applicable range indicated?
Intermittent trouble.
Check for intermittent
referring to “Intermittent
and Poor Connection
Inspection in Section 00
in related manual”.
Go to Step 5.
4
Check transmission range sensor (switch) circuit for
operation.
Check by not using SUZUKI scan tool:
1) Turn ignition switch ON.
2) Check voltage at terminals “G07-1”, “G07-2”, “G07-8”,
“G07-9”, “G07-20” and “G07-21” respectively with select
lever shifted to each range.
Taking terminal “G07-21” as an example, is battery
voltage will be indicated only when select lever is shifted
to “2” range and 0 V for other ranges as shown in table.
Check voltage at other terminals likewise, referring to
table.
Are check results satisfactory?
Intermittent trouble.
Check for intermittent
referring to “Intermittent
and Poor Connection
Inspection in Section 00
in related manual”.
Go to Step 5.
5
Check select cable for adjustment
1) Check select cable for adjustment referring to “Selector
Is it adjusted correctly?
Go to Step 6.
Adjust.
6
Check transmission range sensor for installation
position.
1) Shift select lever to “N” range.
2) Check that “N” reference line on switch and center line
on shaft are aligned.
Are check results satisfactory?
Go to Step 7.
Adjust.
7
Check transmission range sensor
1) Check transmission range sensor (switch) referring to
“Transmission Range Sensor (Shift Switch) Inspection
and Adjustment”.
Are check results satisfactory?
“RED/BLK”, “YEL/RED”,
“YEL” or “RED/BLU”
circuit open or short. If
wires and connections
are OK, substitute a
known-good TCM and
recheck.
Replace Transmission
range sensor.
Terminal
G07-2
G07-1
G07-9
G07-8
G07-21
G07-20
Select lever
position
P
8 – 14 V
0 V
0 V
0 V
0 V
0 V
R
0 V
8 – 14 V
0 V
0 V
0 V
0 V
N
0 V
0 V
8 – 14 V
0 V
0 V
0 V
D
0 V
0 V
0 V
8 – 14 V
0 V
0 V
2
0 V
0 V
0 V
0 V
8 – 14 V
0 V
L
0 V
0 V
0 V
0 V
0 V
8 – 14 V
Summary of Contents for Liana RH418
Page 4: ......
Page 222: ...3A 13 Drive Shaft Axle ...
Page 362: ...5A 136 Automatic Transmission Transaxle ...
Page 370: ...Prepared by 1st Ed Feb 2004 2nd Ed Jul 2006 367 ...
