Suzuki Liana RH418, Supplementary Service Manual

Page: 350 / 371

5A-124 Automatic Transmission/Transaxle:
16) Install special tools on transaxle.
Special tool
(A): 09900–20607
(B): 09900-20701
Measure 1st and reverse brake piston stroke by
applying and releasing compressed air (400 – 800
kPa, 4 – 8 kg/cm
2 , 57 – 113 psi) through oil hole
section (1).
1st and reverse brake piston stroke
Standard: 1.73 – 2.57 mm (0.068 – 0.101 in.)
17) Place compression spring for 2nd and 4th brake into
transaxle case.
18) Apply A/T fluid to new O-rings.
19) Assemble 2nd and 4th brake piston assembly.
a) Install rod washer (4), spring (3), brake piston (2)
and new E-ring (1) to brake piston rod (5).
b) Install brake inner cover (1) and new O-rings (2).
20) Put 2nd and 4th brake piston spring in transaxle
case and insert piston assembly and brake inner
cover into case.
21) Apply valve lifter as shown figure and push piston
cover.
Special tool
(A): 09916-14510
(B): 09916-48210
22) Install snap ring by using snap ring pliers (special
tool) and re-move special tools (A) and (B).
Special tool
(C): 09900-06108
23) Check 2nd and 4th brake piston stroke.
For detail, refer to “Automatic Transaxle Unit
Disassembly”.
If its stroke is out of specification, select proper
piston rod of 5 type instead of original one and
reinstall 2nd and 4th brake piston assembly so as to
be within specification.
Available piston rod length
(1): 122.35 mm (4.817 in.)
(2): 122.60 mm (4.827 in.)
(3): 122.85 mm (4.837 in.)
(4): 123.10 mm (4.846 in.)
(5): 123.35 mm (4.856 in.)
I3RH0B510031-01
I2RH01510116-01
I2RH01510115-01
I2RH01510113-01