Suzuki Liana RH418, Supplementary Service Manual

Page: 333 / 371

Automatic Transmission/Transaxle: 5A-107
Reverse Clutch Preliminary Inspection
S3RH0B5106045
1) Remove sun gear input flange (1) with thrust washer
(2) installed by removing retainer ring (3).
2) Remove input shaft (1) with input shaft rear thrust
roller bearing race (3), input shaft rear thrust roller
bearing (2), input shaft front thrust roller bearing (4)
and input shaft front thrust roller bearing race (5).
3) Remove snap ring (2) of reverse clutch drum with
bearing (1).
4) Install sun gear input flange (thrust washer installed)
with retainer ring.
5) Mount reverse clutch drum with bearing to oil pump
body (1).
6) Measure piston stroke with compressed air (400 –
800 kPa, 4 – 8 kg/cm 2 , 57 – 113 psi) through oil hole
section (2), using special tools.
Special tool
(A): 09900–20607
(B): 09900-20701
Reverse clutch piston stroke
Standard: 1.54 – 1.86 mm (0.061 – 0.073 in.)
NOTE
• To prevent air leakage from oil hole section
(2) during piston stroke measurement with
air nozzle gun, it is recommended to plug
oil hole section around air nozzle gun with
a clean cloth or the like because piston
stroke cannot be measured otherwise.
• If it is difficult to obtain correct specified
value, it is recommended to align plate
(Thickness: approximately 3 mm) with
shape around oil hole section.
I2RH01510184-01
I2RH01510185-01
I2RH01510186-01
I2RH01510187-01