Suzuki Liana RH418, Supplementary Service Manual

Page: 26 / 371

1A-13 Engine General Information and Diagnosis:
Diagnostic Information and Procedures
Engine and Emission Control System Check
S3RH0B1104001
Refer to the following items for the details of each step.
Step Action Yes No
1 Customer complaint analysis )
1) Perform customer complaint analysis referring to
“Customer Complaint Analysis”.
Was customer complaint analysis performed?
Go to Step 2. Perform customer
complaint analysis.
2 DTC(s) check, record and clearance )
1) Check for DTC (including pending DTC) referring to the
“DTC(s) Check, Record and Clearance”.
Is there any DTC(s)?
Print DTC or write it
down and clear it by
referring to “DTC
Clearance”, and go to
Step 3. Go to Step 4.
3 Visual inspection )
1) Perform visual inspection referring to “Visual Inspection”.
Is there any faulty condition?
Repair or replace
malfunction part, and go
to Step 11. Go to Step 5.
4 Visual inspection )
1) Perform visual inspection referring to “Visual Inspection”.
Is there any faulty condition?
Repair or replace
malfunction part, and go
to Step 11. Go to Step 8.
5 Trouble symptom confirmation )
1) Confirm trouble symptom referring to the “Trouble
Symptom Confirmation”.
Is trouble symptom identified?
Go to Step 6. Go to Step 7.
6 Rechecking and record of DTC
)
1) Recheck for DTC referring to “DTC Check”.
Is there any DTC(s)?
Go to Step 9. Go to Step 8.
7 Rechecking and record of DTC )
1) Recheck for DTC referring to “DTC Check”.
Is there any DTC(s)?
Go to Step 9. Go to Step 10.
8 Engine basic inspection and engine symptom diagnosis
)
1) Check and repair according to “Engine Basic Inspection”
and “Engine Symptom Diagnosis”.
Are check and repair complete?
Go to Step 11. Check and repair
malfunction part(s), and
go to Step 11.
9 Troubleshooting for DTC )
1) Check and repair according to applicable DTC diag. flow.
Are check and repair complete?
Go to Step 11. Check and repair
malfunction part(s), and
go to Step 11.
10 Intermittent problems check )
1) Check for intermittent problems referring to “Intermittent
Problems Check”.
Is there any faulty condition?
Repair or replace
malfunction part(s), and
go to Step 11. Go to Step 11.
11 Final confirmation test )
1) Clear DTC if any.
2) Perform final confirmation test referring to “Final
Confirmation Test”.
Is there any problem symptom, DTC or abnormal condition?
Go to Step 6. End.