Suzuki Liana RH418, Supplementary Service Manual

Page: 160 / 371

1D-34 Engine Mechanical:
6) Tighten camshaft housing bolts in such order as
indicated in the figure a little at a time till they are
tightened to specified torque.
NOTE
Do not rotate camshaft while gauging plastic
is installed.
Tightening torque
Camshaft housing bolt (a): Tighten 11 N
⋅
m (1.1
kgf-m, 8.0 lb-ft) by the specified procedure
7) Remove housing, and using scale (2) on gauging
plastic envelop, measure gauging plastic (1) width at
its widest point.
Camshaft journal clearance
If measured camshaft journal clearance exceeds
limit, measure journal (housing) bore and outside
diameter of camshaft journal. Replace camshaft or
cylinder head assembly whichever the difference
from specification is greater.
Camshaft journal specification
Item Standard Limit
Intake side
No.1 housing
0.020 – 0.072 mm
(0.0008 – 0.0028 in.)
0.10 mm
(0.0039 in.)
Others
0.045 – 0.087 mm
(0.0018 – 0.0034 in.)
0.12 mm
(0.0047 in.)
“10” “9” “2” “1”,(a) “6” “5” “14” “13”
“20”
“17”
“19”
“18”
“21”
“12” “11” “4” “3” “8” “7” “16” “15”
I3RH0B140041-01
I2RH0B140083-01
Item Standard
Camshaft
journal
diameter [A]
Intake side
No.1 housing
26.940 – 26.955 mm
(1.0607 – 1.0612 in.)
Exhaust side
No.1 housing
26.934 – 26.955 mm
(1.0604 – 1.0612 in.)
Others
22.934 – 22.955 mm
(0.9030 – 0.9037 in.)
Camshaft
journal
bearing bore
[B]
Intake side
No.1 housing
—
Exhaust side
No.1 housing
27.000 – 27.021 mm
(1.0630 – 1.0638 in.)
Others
23.000 – 23.021 mm
(0.9056 – 0.9063 in.)
I2RH0B140084-01