Suzuki Liana RH418, Supplementary Service Manual

Page: 214 / 371

3A-5 Drive Shaft / Axle:
2) Slide boot (1) toward the center of shaft and remove
snap ring (2) from outer race, and then take shaft out
of outer race (3).
3) Wipe off grease and remove circlip (1) used to fix
cage (2) using special tool.
Special tool
(A): 09900-06107
4) Draw away cage (1) using bearing puller (2), and
remove boot (3) from shaft.
5) Remove differential side boot small band, and then
pull out differential side boot from shaft.
6) Remove damper band, and then pull out damper
through shaft.
7) Remove wheel side boot big band (1) using flat end
rod or the like.
8) Remove wheel side boot small band (2), and then
pull out wheel side boot from shaft.
CAUTION
!
Do not disassemble wheel side joint. If any
malcondition is found, replace it as
assembly.
For center shaft
1) Using hydraulic press (1), draw out center shaft (2)
from center bearing support (3).
I2RH01310012-01
I4RH01311003-01
I2RH01310014-01
1
2
I3RH0B311001-01
IYSY01311021-01