Suzuki Liana RH418, Supplementary Service Manual

Page: 184 / 371

1D-58 Engine Mechanical:
d) Tighten bolts (11) – (20) to 25 N
⋅
m (2.5 kgf-m,
18.0 lb-ft) according to numerical order as
shown.
Tightening torque
Crankshaft bearing cap No.1 bolt (1) – (10):
Tighten 30 N
⋅
m (3.0 kgf-m, 22.0 lb-ft), 50 N
⋅
m
(5.0 kgf-m, 36.5 lb-ft) and 60
°
by the specified
procedure
Crankshaft bearing cap No.2 bolt (11) – (20):
Tighten 25 N
⋅
m (2.5 kgf-m, 18.0 lb-ft) by the
specified procedure
CAUTION
!
After tightening cap bolts, check to be sure
that crankshaft rotates smoothly when
turning it by 12 N
⋅
m (1.2 kgf-m, 9.0 lb-ft)
torque or below.
7) Apply sealant to mating surface of rear oil seal
housing (1).
“A”: Water tight sealant 99000–31250
Sealant amount for rear oil seal housing
Width: “a”: 3 mm (0.12 in.)
Height “b”: 2 mm (0.08 in.)
8) Install rear oil seal housing (1) and tighten bolts to
specified torque by using special tool.
Special tool
(A): 09911–97720
Tightening torque
Rear oil seal housing bolt: 11 N·m (1.1 kgf-m, 8.0
lb-ft)
9) Install flywheel (drive plate for A/T).
Using special tool, lock flywheel or drive plate, and
tighten flywheel or drive plate bolts applied with
sealant to specification.
“A”: Sealant 99000–31110
Special tool
(A): 09924–17811
Tightening torque
Flywheel or drive plate bolt (a): 70 N·m (7.0 kgf-
m, 51.0 lb-ft)
I2RH0B140131-01
I3RH0B140049-01
I2RH0B140133-01
I2RH0B140134-01