Suzuki Liana RH418, Supplementary Service Manual

Page: 154 / 371

1D-28 Engine Mechanical:
8) Screw in plunger (1) by turning timing chain
tensioner adjuster (2) in arrow direction and install a
retainer (3) (wire) to hold plunger in place.
9) Install timing chain tensioner adjuster assembly (1)
with a retainer (2).
Tighten adjuster bolts to specified torque and then
remove a retainer from chain tensioner adjuster
assembly.
Tightening torque
Timing chain tensioner adjuster bolt (a): 11 N·m
(1.1 kgf-m, 8.0 lb-ft)
10) Apply engine oil to timing chain and then turn
crankshaft clockwise by 2 revolutions and check that
match marks (1) on intake and exhaust camshaft
timing sprockets are in match with notches (2) on
cylinder head and key (3) is in match with notch (4)
on cylinder block as shown in the figure.
If each mark of timing chain and each match mark
are no matches, adjust each sprocket and timing
chain.
11) Install timing chain cover referring to “Timing Chain
Cover Removal and Installation”.
12) Perform Steps 11) to 16) of “Installation” of “Timing
Chain Cover Removal and Installation”.
I2RH0B140065-01
I2RH0B140066-01
1
1
2
3
4
I3RH0B140036-01