Suzuki Liana RH418, Supplementary Service Manual

Page: 355 / 371

Automatic Transmission/Transaxle: 5A-129
65) Apply sealant to thread parts of 2 bolts (1).
“A”: Sealant 99000–31230
66) Install transaxle housing to transaxle case by
tightening bolts to specified torque.
Tightening torque
Transaxle case bolt (a): 30 N·m (3.0 kgf-m, 22.0
lb-ft)
67) Insert wiring harness (1) of valve body connectors.
68) Apply A/T fluid to 2 new gaskets (2) and place them
as shown in figure.
69) While holding valve body assembly (1), connect
manual valve rod (2) to manual valve lever (3).
70) Tighten valve body assembly (1) with bolts referring
to length in the following table.
Bolt: Length “L”
(1): 20 mm
(2): 50 mm
(3): 55 mm
(4): 75 mm
Tightening torque
Valve body bolt (a): 10 N·m (1.0 kgf-m, 7.5 lb-ft)
71) Clamp wiring harness (1) of solenoids and
transmission fluid temperature sensor.
72) Connect couplers of solenoids by identifying wire
color shown in the following table and install
transmission fluid temperature sensor (6) to its
clamp (7).
NOTE
There is an interchangeability between shift
solenoid valve-A and shift solenoid valve-B
for installation.
(a)
(a)
(a)
1, “A”, (a)
(a)
(a)
I2RH01510258-01
I2RH01510259-01
1
3
2
I2RH01510260-01
Solenoid Coupler Wire Color
Pressure control solenoid valve (2) Pink + Brown
Shift solenoid valve-A (No.1) (3) White
Shift solenoid valve-B (No.2) (4) Black
TCC solenoid valve (5) Yellow
I3RH0B510015-01
1
2
3
4
5
6
7
I2RH01510262-01