Suzuki 2000 Grand Vitara SQ416, Service Manual

Page: 721 / 729

YH4
GRAND
VITARA
1. End housing bearing
2. Rotor
3. Bearing cover
3. Drive end bearing
4. Stator 1. Stud bolt
2. Retaining plate
1. Rotor 2. Drive end frame
1. Rear end frame 2. Drive end frame
1. Pulley
2. Hexagonal box
wrench
3. Offset wrench
1, (a)
6H-28 CHARGING SYSTEM
REASSEMBLY [70 A and 85 A types]
1) If end housing bearing is removed, install it.
2) Check end housing bearing turns smoothly.
3) If stator is removed, install stator and tighten stud bolts.
4) If drive end bearing is removed, install it.
5) Check drive end bearing turns smoothly.
Tightening Torque
(a): 8.8 N
.
m (0.88 kg-m, 6.5 lb-ft)
(b): 2.6 N
.
m (0.26 kg-m, 2.0 lb-ft)
6) Place drive end frame on pulley, and then install rotor to drive
end frame.
7) Install rear end frame to drive end frame.
8) Tighten 4 nuts to specified torque.
Tightening Torque
(a): 4.5 N
.
m (0.45 kg-m, 3.5 lb-ft)
9) Install pulley and tighten pulley nut with holding shaft by using
hexagonal box wrench to specified torque.
Tightening Torque
(a): 111 N
.
m (11.1 kg-m, 80.5 lb-ft)