Suzuki 2000 Grand Vitara SQ416, Service Manual

Page: 714 / 729

YH4
GRAND
VITARA
1. Rear end frame
2. Rotor shaft 3. Rear end frame nut
1. End housing bearing
2. Bearing puller
3. Bearing cover
1. Stud bolt
2. Retaining plate 3. Drive end bearing
4. Stator
CHARGING SYSTEM 6H-21
9) Remove 4 rear end frame nuts.
10) Drive out rear end frame with rotor tapping shaft lightly by using
plastic hammer.
11) Separate rear end frame from rotor evenly by using plastic
hammer.
CAUTION:
Do not hit shaft at slip ring side, when separating rotor
and rear end frame.
12) If required, use bearing puller to remove end housing bearing
and bearing cover.
CAUTION:
Care must be exercised so as not to distort cooling fan
blade while applying puller.
13) If required, remove 4 screws, retainer plate and then drive out
drive end bearing.
14) If required, remove stud bolts and then pull out stator.
NOTE:
Heating drive end frame may facilitate removal of stator.