YH4
GRAND
VITARA
ENGINE (H25 ENGINE)
6-1-57
Fig. for STEP 5
Fig. for STEP 6
D
Atmospheric pressure: higher than 560 mmHg (Altitude: lower than 2790 m (9150 ft))
D
Intake air temperature: between – 14
_
C and 70
_
C (6.8
_
F and 158
_
F)
(1) With ignition switch OFF, connect scan tool.
(2) Turn ON ignition switch, clear DTC if any.
(3) Start engine and run it for 10 sec.
(4) Check DTC by using scan tool.
DTC TROUBLESHOOTING
STEP
ACTION
YES
NO
1
Was “ENGINE DIAG. FLOW TABLE” performed?
Go to Step 2.
Go to “ENGINE
DIAG. FLOW
TABLE”.
2
Check ECT Sensor and Its Circuit.
1) Connect scan tool with ignition switch OFF.
2) Turn ignition switch ON.
3) Check engine coolant temp. displayed on scan tool.
Is – 40
_
C (– 40
_
F) or 205
_
C (401
_
F) indicated?
Go to Step 3.
Intermittent trouble.
Check for intermittent
referring to
“Intermittent and
Poor Connection” in
Section 0 A.
3
Check Wire Harness.
1) Disconnect ECT sensor connector.
2) Check engine coolant temp. displayed on scan tool.
Is – 40
_
C (– 40
_
F) indicated?
Replace ECT sensor.
“Or / B” wire shorted
to ground.
If wire is OK,
substitute a known-
good ECM and
recheck.
4
Does scan tool indicate – 40
_
C (– 40
_
F) at Step 2.
Go to Step 6.
Go to Step 5.
5
Check Wire Harness.
1) Disconnect ECT sensor connector (1) with ignition
switch OFF.
2) Check for proper connection to ECT sensor at
“Gr / Y” and “Or / B” wire terminals.
3) If OK, then with ignition switch ON, is voltage
applied to “Or / B” wire terminal about 4.5 – 5.5 V?
Go to Step 4.
“Or / B” wire open or
shorted to power, or
poor C51-3-22
connection.
If wire and
connection are OK,
substitute a known-
good ECM and
recheck.
6
Check Wire Harness.
1) Using service wire (2), connect ECT sensor
connector terminals. See Fig. 2.
2) Turn ignition switch ON and check engine coolant
temp. displayed on scan tool.
Is 205
_
C (401
_
F) indicated?
Replace ECT sensor.
“Gr / Y” wire open or
poor C51-3-20
connection.
If wire and
connection are OK,
substitute a known-
good ECM and
recheck.
Summary of Contents for 2000 Grand Vitara SQ416
