Suzuki 2000 Grand Vitara SQ416, Service Manual

Page: 273 / 729

YH4
GRAND
VITARA
ENGINE MECHANICAL (G16 ENGINE) 6A1-31
1. Key
2. Crank timing belt pulley
3. Pulley bolt
4. Dowel pin (crankshaft pulley pin)
5. Flywheel
(Drive plate for A / T)
5
5) Install timing pulley key and crank timing belt pulley. Refer to
figure for proper installation of these parts.
With crankshaft locked, tighten crank timing belt pulley bolt to
specified torque.
Tightening Torque
(a): 130 N
.
m (13.0 kg-m, 94.0 lb-ft)
Special Tool
(A): 09927-56010
6) Install timing belt, tensioner, oil pump strainer, oil pan and other
parts as previously outlined.
7) Check to ensure that all removed parts are back in place. Rein-
stall any necessary parts which have not been reinstalled.
8) Adjust water pump drive belt tension, referring to “ENGINE
COOLING” section.
9) Adjust power steering pump belt tension or A / C compressor
belt tension, if equipped. Refer to section 0B.
10) Refill engine with engine oil, referring to item “ENGINE OIL
CHANGE” in section 0B.
11) Refill front differential housing with gear oil, referring to “DIF-
FERENTIAL” section.
12) Connect negative cable at battery.
13) Verify that there is no coolant leakage and each oil leakage at
each connection.
14) After completing installation, check oil pressure by running en-
gine.