Suzuki 2000 Grand Vitara SQ416, Service Manual

Page: 442 / 729

YH4
GRAND
VITARA
1. Generator belt
idler pulley
2. A / C compressor
bracket
3. Radiator outlet hose
1. Crankshaft pulley
2. Bolt
3. Wrench
1. Crankshaft pulley
1. Timing chain cover
2. Oil seal
ENGINE MECHANICAL (J20 ENGINE) 6A4-23
11) Remove generator belt idler pulley.
12) Disconnect radiator outlet hose from thermostat cap.
13) With hoses connected, detach A / C compressor from com-
pressor bracket if equipped.
14) Remove A / C compressor bracket if equipped.
15) Remove crankshaft pulley bolt.
To lock crankshaft pulley, use special tool (camshaft pulley
holder) with it as shown in figure.
Special Tool
(A): 09917-68221
NOTE:
Be sure to use the following bolt for fixing special tool to
crankshaft pulley.
Bolt size: M8, P1.25, L = 45 mm
Strength: 7T
16) Remove crankshaft pulley.
If it is hard to remove, use special tools (Steering wheel remov-
er and Bearing puller attachment) as shown in figure.
If bolts of steering wheel remover are too long, replace them
with those of suitable length.
Special Tool
(A): 09944-36011
(B): 09926-58010
17) Remove timing chain cover.
CLEAN
Clean sealing surface on timing chain cover, crankcase, cylinder
block and cylinder head.
Remove oil, old sealant, and dust from sealing surface.
INSPECTION
Check oil seal lip for fault or other damage.
Replace as necessary.
NOTE:
When installing new oil seal, tap it in until its surface is flash
with edge of timing chain cover.
To install oil seal, use special tool (bearing installer).
Special Tool
(A): 09913-75510