Suzuki 2000 Grand Vitara SQ416, Service Manual

Page: 437 / 729

YH4
GRAND
VITARA
6A4-18 ENGINE MECHANICAL (J20 ENGINE)
1. Oil pump
2. O-ring
3. Oil pump strainer
4. Oil pan
1. Oil pan
2. Drain plug
3) Install O-rings in the position as shown in figure and install oil
pump strainer to oil pump.
Tighten strainer bolts first and then bracket bolt to specified
torque.
Tightening Torque
(a): 11 N
.
m (1.1 kg-m, 8.0 lb-ft)
(b): 11 N
.
m (1.1 kg-m, 8.0 lb-ft)
4) After fitting oil pan to cylinder block, run in securing bolts and
start tightening at the center: move wrench outward, tightening
one bolt at a time.
Tighten bolts and nuts to specified torque.
Tightening Torque
(c): 11 N
.
m (1.1 kg-m, 8.0 lb-ft)
5) Lower engine and tighten engine mounting nuts to specified
torque referring to “Engine Assembly Installation” in this sec-
tion.
6) Install gasket and drain plug to oil pan.
Tighten drain plug to specified torque.
Tightening Torque
(a): 35 N
.
m (3.5 kg-m, 25.5 lb-ft)
7) Install clutch (torque converter) housing lower plate.
8) Connect exhaust pipe to exhaust manifold referring to Section
6K.
9) Install transmission stiffener to transmission and cylinder block
if equipped.
10) Install front differential housing according to installation proce-
dure described in Section 7E.
11) Refill front differential housing with gear oil, referring to Section
7E.
12) Install steering gear box to vehicle referring to “Steering Gear
Box Installation” in Section 3B1.
13) Install oil level gauge.
14) Refill engine with engine oil, referring to item “ENGINE OIL
CHANGE” in Section 0B.
15) Refill power steering system with specified fluid referring to
Section 3B1.
16) Verify that there is no engine oil leakage, differential oil leakage
and power steering fluid leakage at each connection.