Suzuki 2000 Grand Vitara SQ416, Service Manual

Page: 176 / 729

YH4
GRAND
VITARA
ENGINE (H25 ENGINE) 6-1-65
DTC P0134 HO2S (BANK-1 SENSOR-1) NO ACTIVITY DETECTED
(DTC No.13)
WIRING DIAGRAM
Refer to DTC P0130.
DTC DETECTING CONDITION AND TROUBLE AREA
DTC DETECTING CONDITION TROUBLE AREA
HO2S voltage is lower than 0.5 V. HO2S
HO2S circuit
Fuel injector
Fuel pressure control system
ECM (PCM)
DTC CONFIRMATION PROCEDURE
WARNING:
D
When performing a road test, select a place where there is no traffic or possibility of a traffic accident
and very careful during to avoid occurrence of an accident.
D
Road test, should be carried out with 2 person, a driver and tester, on a level road.
NOTE:
Check to make sure that following conditions are satisfied when using this DTC CONFIRMATION PROCE-
DURE.
D
Intake air temperature: between – 14
_
C and 70
_
C (6.8
_
F and 158
_
)
D
Atmospheric pressure: higher than 560 mmHg (Altitude: lower than 2790 m (9150 ft))
D
Following DTCs are not detected: P0100, P0115 and P0135
(1) With ignition switch OFF, connect scan tool.
(2) Turn ON ignition switch and clear DTC by using scan tool if any.
(3) Start engine and warm up to normal operating temperature (Run engine for 2 min. or more).
(4) Increase vehicle speed to 65 – 80 km / h (40 – 50 mph).
(5) Keep above vehicle speed for 2 min. (Throttle valve operating is kept constant in this step.)
(6) Stop vehicle and check DTC and pending DTC by using scan tool.
DTC TROUBLE SHOOTING
STEP ACTION YES NO
1 Was “ENGINE DIAG. FLOW TABLE” performed? Go to Step 2. Go to “ENGINE
DIAG. FLOW
TABLE”.
2 HO2S Voltage check:
(1) With ignition switch OFF, install scan tool.
(2) Operate engine for 60 sec. or more with following
condition.
Engine coolant temp. > 70
_
C
Engine speed > 2000 r / min.
(3) With above condition, check “O2S B1 S1”
(HO2S voltage) displayed on scan tool.
Does above voltage deflect over and under 0.5 V?
Intermittent trouble.
If OK, substitute a
known-good ECM
(PCM) and recheck. Go to Step 3.