Siemens SITRANS FUS1020, Manual, Page: 54 / 251

2-35
1020NFM-1D
Section 2
z
Upon completion, the meter beeps and the LCD screen shows the prompt:
Reverse XDCRs Press [ENT].
z
You must now remove and then remount the upstream and downstream transducers in their re-
versed positions (i.e., Mount the Up Transducer with its cable in the Down Transducer/cable loca-
tion. Mount Down Transducer with its cable in the Up Transducer/cable location). If possible, this
procedure should be done without removing the transducer cables from the transducers. When
remounting the transducers, couple them to the pipe properly.
z
After re-installing the transducers, press [ENTER]. The computer measures the negative flow rate
briefly, then beeps and repeats the prompt:
Reverse Xdcrs Press [ENT]. You must now re-
mount the transducers for normal operation (in their original orientation). When remounting trans-
ducers, couple them to the pipe properly.
Transducer Model 1021 Xdcr
Transducer Size C1
Xdcr Mount Mode Reflect
Spacing Offset Invalid low
Number Index 4
Spacing Method Invalid
Ltn Value Auto Zero
Install Complete? ZeroMatic
Empty Pipe Set ZeroClr
Zero Flow Adjust Actual Zero
>ReverseMatic
Siemens 2 Channel [1] SITE1
Reverse XDCRs Press [ENT]
Pick/Install Xdcr
Transducer Model 1021 Xdcr
Transducer Size C1
Xdcr Mount Mode Reflect
Spacing Offset Invalid low
Number Index 4
Spacing Method Invalid
Ltn Value Auto Zero
Install Complete? ZeroMatic
Empty Pipe Set ZeroClr
Zero Flow Adjust Actual Zero
>ReverseMatic
Siemens 2 Channel [1] SITE1
ReversaMatic Active [6: :0]
Pick/Install Xdcr