RR Mechatronics STARRSED RS, User Manual

Page: 164 / 259

▪ Tube motor position error
▪ Blockage of the Outer needle
▪ Faulty Outer needle motor
▪ Faulty Tube motor driver on the needle board
E20
Outer needle motor position error ! (piercing error).
The Outer needle could not go down all the way. This can be caused by:
▪ Piercing position sensor was triggered
▪ Piercing position sensor was not triggered, check the piercing position sensor
▪ Tube 1 not aligned properly, check the tube 1 position setting and save the setting
For other error numbers and details See the Appendix - Error list Starrsed RS
bij wijziging ook txt 18185 bekijken
15.19 - New rack adapter
Go to
Service screen
and select
Position motor
-
Select rack
and select the required rack type.
Go to
Test position
motor and
Go to TUBE
position and set in Tube # number 1.
The Gripper motor will move the rack to the first position of the rack. Check if the needle is above the first
hole. If the needle is not above the first hole turn the wheel on the motor until the needle is above the hole.
Check that the needle is going though the hole by using the Outer needle function
DOWN
.
Get the needle out of the hole press the function
UP
.
By turning the wheel the actual position numbers are changed.
When the needle is going nicely through the hole press the
Save as Tube 1 position
.
Next step is press Save settings.
Now all the new settings are saved in the file and Eeprom.
15.20 - Rack unit errors
The rack unit can give errors on the
• Gripper module
• Mixer module
• Mixer module
15.20.1 - Gripper module
E61 till E67, E69, E71 E72, E80 till E88 are the error codes and the text in the status line begins with
" Grabber did not reach the ":
Troubleshooting
164
MRN-071-2-EN version 7.02 Starrsed RS