RR Mechatronics STARRSED RS, User Manual

Page: 163 / 259

15.17 - Fill nozzle
Normally the fill sequence takes about 3 seconds. However, if the fill sequence exceeds 10 seconds, a fill
time-out error will be generated. The ESR analyser unit aborts the fill sequence and this error message will
be shown on the display and reported.
Check for mechanical obstructions and remove them. If the error returns, call for service.
15.17.1 - Fill nozzle does not engage with pipette
1. Motor time out generated, fill nozzle stops half way up.
2. Check for mechanical obstruction.
3. Motor failure. Fatal error, call distributor.
15.17.2 - Fill nozzle not at fill position
E8 is the error code and in the status line the text Fill nozzle not in the fill position.
The fill nozzle did not reach the fill position in a certain time limit.
Possible reason;
• Fill nozzle motor is faulty.
• Fill nozzle motor driver is faulty.
• Fill nozzle is blocked.
• Fatal error, call distributor.
15.17.3 - Fill nozzle not at home position
E13 is the error code and in the status line the text Fill nozzle did not reach the Home position within a
certain time limit.
The fill nozzle did not reach the home top sensor with a certain time limit.
• Fill nozzle motor faulty.
• Fill nozzle motor driver is faulty.
• Fill nozzle is blocked.
• Fatal error call distributor.
15.18 - Piercing error
There are two error codes related to a piercing error: E7 and E20.
E7 Outer needle motor position error ! Timeout ! (piercing)
The Outer needle did not go down within a certain time limit. This can be caused by:
Troubleshooting
MRN-071-2-EN version 7.02 Starrsed RS
163