Rohde & Schwarz EVSG1000, User Manual

Page: 65 / 311

Numeric Measurement Modes
R&S
®
EVSG1000
65 User Manual 1178.6227.02 ─ 04
You can display graphical results directly from the ILS Marker Beacon mode by select-
ing the softkey in the "Meas" menu. In this case, the settings for the current measure-
ment are applied to the graphical results.
To return from the graphical results to the ILS Marker Beacon mode, select "Return"
([F8]).
For details on the graphical results, see:
●
Chapter 6.1, "RF Spectrum Mode (Option R&S EVSG-K10)" , on page 100
●
Chapter 6.2, "IF Spectrum Mode (Option R&S EVSG-K10)" , on page 105
●
Chapter 6.3, "AF Spectrum Mode (Option R&S EVSG-K11)" , on page 110
●
Chapter 6.4, "AF Time Domain Mode (Option R&S EVSG-K12)" , on page 115
Remote command:
VIEW_MB
on page 241
● RF Level and Frequency Display ............................................................................65
● IF Spectrum Preview ...............................................................................................66
● ILS Marker Beacon Main View ................................................................................67
● ILS Marker Beacon ID Analysis .............................................................................. 68
● ILS Marker Beacon Recording View ....................................................................... 70
5.2.2.1 RF Level and Frequency Display
The measured RF power and frequency of the input signal is displayed both numeri-
cally and graphically.
Figure 5-10: RF level display
The following results are provided:
●
Numeric power level in dBm ("Lev")
For measurements on two frequencies: individual and sum power levels
●
Measured frequency offset to the nominal frequency in kHz
●
Numeric frequency offset of measured power
●
Numeric power sensor level in dBm (if available; "NRP")
●
Bargraph indicating the power and a color-coded overload state, where:
–
red : overload state, check message
– yellow : power approaching overload state
ILS Marker Beacon Mode (Option R&S EVSG-K3)