Rohde & Schwarz EVSG1000, User Manual

Page: 175 / 311

Common Instrument Settings
R&S
®
EVSG1000
175 User Manual 1178.6227.02 ─ 04
11 Common Instrument Settings
Common instrument settings are applied regardless of which measurement mode is
selected.
Configuring screenshots is described in Chapter 10, "Data Management" ,
on page 166.
Configuring the signal input is described in
Chapter 4.1, "Input Signal Settings" ,
on page 39.
11.1 Audio Output Settings
Access : [Audio]
Access VNC : [c]
(Not in "Preset" view.)
Audio output is available at the loudspeaker on the rear panel or the headphones con-
nector on the front panel of the R&S
EVSG1000.
For example, the demodulated identifier in ILS mode is output as a 1020 Hz morse sig-
nal.
AF Volume ...................................................................................................................175
Squelch ....................................................................................................................... 175
Demod .........................................................................................................................176
Audio BW .................................................................................................................... 176
Speaker .......................................................................................................................176
KB Beep ...................................................................................................................... 176
AF Volume
Defines the volume of the AF output at the at the loudspeaker or the headphones con-
nector. Enter a percentage value (0
% to 100 %).
Remote command:
SETUP:VOLUME
on page 205
Squelch
Defines the level threshold below which the demodulated data is set to 0. This is use-
ful, for example, to avoid demodulation noise during transmission breaks.
This setting is only relevant for numeric measurement modes.
The squelch level is an absolute value.
The current squelch level is indicated numerically on the softkey and graphically on the
bargraph indicator.
Remote command:
SQUELCH
on page 205
Audio Output Settings