Rohde & Schwarz EVSG1000, User Manual

Page: 118 / 311

Graphic Measurement Modes
R&S
®
EVSG1000
118 User Manual 1178.6227.02 ─ 04
6.4.3 Configuring the Measurement Time
Access : [MTime] > "Time/Div"
Access VNC : [d] > "F1"
Time/Div
Defines the time range displayed in each division of the x-axis. The full x-axis range,
that is: the total measurement time, is eight times this value.
Remote command:
SCOPE_TIMEDIV_RF
on page 277
6.4.4 Configuring the Trigger
Access : [Trigger]
Access VNC : [k]
The trigger determines how often and when a new measurement is performed.
Performing a single sweep
To perform a single sweep, press [Single] (VNC: [L]).
Trigger mode ............................................................................................................... 118
Trigger Source .............................................................................................................118
Trigger Edge ................................................................................................................119
Trigger Level ................................................................................................................119
Trigger mode
Determines how the trigger is evaluated.
"Norm" Each time a trigger event occurs, a measurement is performed.
"Auto" Each time a trigger event occurs, a measurement is performed.
If no trigger event occurs during a predefined waiting period, a mea-
surement is performed without a trigger. This helps you determine the
required trigger level.
"Single" When the trigger event occurs, a single measurement is performed.
Trigger Source
Determines how often and when a new sweep is performed.
"Ext." A measurement is performed each time a trigger signal from a con-
nected external trigger device is received. The trigger device must be
connected to the "Trigger In" connector on the rear panel of the
R&S
EVSG1000.
"Level" A measurement is performed when the input signal reaches the
defined trigger level.
AF Time Domain Mode (Option R&S EVSG-K12)