Rohde & Schwarz EVSG1000, User Manual

Page: 116 / 311

Graphic Measurement Modes
R&S
®
EVSG1000
116 User Manual 1178.6227.02 ─ 04
The currently active receiver board. See Chapter 4.2, "Receiver Board" ,
on page 40.
●
Measurement mode
The currently active measurement mode on the active receiver board, e.g. "AF
Spectrum". See
Chapter 4.3, "Measurement Mode" , on page 41.
●
"RF Freq"
Nominal measurement frequency of the RF signal, see
"RF Freq" on page 111.
●
RF attenuation ("Att")
The used attenuation mode; see also
"RF Mode" on page 60.
●
Y-axis scaling ("Y % / Div")
Range per y-axis division. See
"Y % /Div" on page 117.
●
X-axis scaling ("Time / Div")
Time per x-axis division. See
"Time/Div" on page 118.
Remote command to select RF Spectrum mode:
MODE_SCOPE
on page 276
Remote command to retrieve trace results:
SCOPE_GETMEAS
on page 278
6.4.1 Configuring the Frequency Range
Access : [CH F]
Access VNC : [q]
The following settings configure the measured frequency of the time domain measure-
ment.
RF Freq ....................................................................................................................... 116
RF Freq
Configures the nominal frequency of the measurement. The configured value is dis-
played as "RF Freq" in the measurement settings area.
Remote command:
SCOPE_FREQRF
on page 276
6.4.2 Configuring the Amplitude (Y-Axis)
Access : [Ampt]
Access VNC : [w]
The amplitude settings configure the y-axis of the spectrum.
Y % /Div .......................................................................................................................117
RF Att .......................................................................................................................... 117
RF Mode ......................................................................................................................117
AF Time Domain Mode (Option R&S EVSG-K12)