Rohde & Schwarz EVSG1000, User Manual

Page: 170 / 311

Data Management
R&S
®
EVSG1000
170 User Manual 1178.6227.02 ─ 04
List ...............................................................................................................................170
Clear List ..................................................................................................................... 170
Time ............................................................................................................................ 170
Data selection (Sel, not GBAS/SCAT-I mode) .............................................................170
Data selection (Select, GBAS/SCAT-I mode only) ...................................................... 171
└ Parameter ..................................................................................................... 171
└ Msg Log ........................................................................................................ 171
└ IQ Log ........................................................................................................... 171
└ Slot <x> Log ..................................................................................................171
Export List to USB .......................................................................................................171
List
Selects a specific data set list (1 to 999, the list number is shown in the softkey).
Remote command:
SETACTIVELIST
on page 282
GETACTIVELIST
on page 280
Clear List
Deletes all entries in the current list.
Remote command:
CLEARACTIVELIST
on page 279
Time
Specifies how often an entry is appended to the data list. Enter the time in millisec-
onds.
Note that the minimum spacing between two values is defined by the availability of
measurement result values (see
Chapter 5.1.4.4, "Setting the Measurement Time
(MTime)" , on page 62). If more values are available than are stored, that is: "Time" >
Setting the Measurement Time (MTime) , the calculated values are averaged to obtain
only the required number of results.
In GBAS/SCAT-I mode, one record is stored for each slot, in a time interval of 62.5 ms,
as long as recording is active. The time interval cannot be edited.
Data selection (Sel, not GBAS/SCAT-I mode)
By default, the whole data set is recorded. You can configure the scope of the data to
be displayed and exported. For details on the individual data sets, see the remote com-
mand (
SELECTLISTPARAM
on page 282).
"All" Includes all EVSG1000 and R&S EVS300 values.
"Full" Compatible to R&S EVS300.
"Medium" A reduced set of values
"Short" A minimum set of values
Remote command:
SELECTLISTPARAM
on page 282
Recording Measurement Data