R&S ZNL, User Manual

Page: 137 / 1135

General instrument setup
R&S
®
ZNL/ZNLE
137 User Manual 1178.5966.02 ─ 19
7.5.3 Calibration signal display
Access : [Setup] > "Service" > "Calibration Signal"
Alternatively to the RF input signal from the front panel connector you can use the
instrument's calibration signal as the input signal, for example to perform service func-
tions on.
NONE .........................................................................................................................137
Calibration Frequency RF ........................................................................................... 137
└ Frequency ..................................................................................................... 137
Calibration Frequency MW ..........................................................................................138
NONE
Uses the current RF signal at the input, i.e. no calibration signal (default).
Remote command:
DIAGnostic:SERVice:INPut[:SELect]
on page 606
Calibration Frequency RF
Uses the internal calibration signal as the RF input signal.
Remote command:
DIAGnostic:SERVice:INPut[:SELect]
on page 606
DIAGnostic:SERVice:INPut:PULSed:CFRequency
on page 606
Frequency ← Calibration Frequency RF
Defines the frequency of the internal broadband calibration signal to be used for IF fil-
ter calibration (max. 64
MHz).
Service functions