46 . OilExpress 4 System User's Guide
Figure 24 Liquid presence sensor indicating no sample detected
The sensor is connected to the rear of the FCM, and is powered by the FCM (not the sample
shuttle).
NOTE: If the LED is not lit, check that the sensor is connected to the FCM. Refer to
on page 50 or
starting on page 128.
Connections on the Spectrometer
The Spectrum Two power supply adaptor can operate on electricity supplies of 50 or 60 Hz
and in the 100 to 230 V range without any adjustment. The mains power cord supplied will
depend on the requirements of your region. The Spectrum Two spectrometer uses an 18 V
power adaptor.
The power adaptor connector and communications ports are on the rear of the spectrometer
Figure 25 Power adaptor port on rear of the instrument
Connection to
shuttle
Connection to
Spectrum Two
power supply
adaptor
Diagnostic
LED
18 V DC power
adaptor port
Summary of Contents for OilExpress 4
