Palfinger PK 34002-SH P7, Original Operating Manual

Page: 163 / 260

Chapter 7 Preparing for crane operation
157
Cable operation
Note!
Cable operation is used as an emergency back-up mode if the
wireless link fails.
Cable mode is also provided for use in areas where emitting wireless
signals is not allowed (e.g. hospitals, nuclear power plants, etc.)
Setting up cable operation
Cable operation is established by attaching the connection cable supplied between the remote control
console and the receiver.
1. Switch off the remote control console.
2. Remove plug connectors' protective caps and connect cable as shown.
3. Restart console (as for wireless mode).
Note!
In cable operation the system does not emit any radio signals.
Cable operation is also possible with no battery fitted.
A 15m long cable is supplied with each system.
Re-establish wireless operation
Cable operation is ended by disconnecting the cable.
1. Switch off the remote control console.
2. Disconnect cable, screw protective caps back on.
3. Insert battery.
4. Start wireless operation.