Palfinger PK 34002-SH P7, Original Operating Manual

Page: 104 / 260

Safety equipment
98
Manual lever error:
Gets shown if when the system is started a lever has already
been actuated or any stabilization functions get triggered during
crane operation.
Remedy:
x
Move lever into neutral position.
x
Quit pop-up - if the error persists, contact
PALFINGER service partner.
Sensor signal comparison:
Gets shown if the sensors’ signal values are not the same.
Remedy:
x
Quit pop-up - if the error persists, contact
PALFINGER service partner.
Oil status error:
Gets shown if the oil temperature or fill level is outside the
specified warning limits.
Remedy:
x Check oil status and depending on display
allow crane to cool down or top up oil.
x Quit pop-up - if the error persists, contact
PALFINGER service partner.
x
If necessary, retrofit oil cooler.
Console tilted:
Gets shown if the transmitter's maximum tilt sensor gets triggered.
The remote control console has been tilted at too great an angle
or has been dropped. This deactivated the functions of the levers.
Remedy:
x
Turn switch further to START and hold in this
position for about 2 seconds until you hear a
beep.
The operating levers get activated.