![background image](http://html1.mh-extra.com/html/omron/scara-r6y-xe-series/scara-r6y-xe-series_maintenance-manual_743985038.webp)
4
Adjusting the or
ig
in
4-8
1.2.2 Adjusting the Y-axis machine reference
CAUTION
The origin position may change due to machine reference adjustment. If it occurs, you must set point data again.
Follow the steps below to adjust the Y-axis machine reference value.
Prepare a wrench for a width across flat of 13 mm.
Step1
Turn on the controller.
Check that no one is inside the safety enclosure, and then turn on the controller.
Step2
Perform the return-to-origin.
Perform the return-to-origin from outside the safety enclosure.
For details about how to perform the return-to-origin, refer to "2.3 Return-to-origin procedures" in this
Chapter.
Step3
Check the machine reference value.
If the machine reference value displayed on the PBEX is not in the range between 25 and 75
(recommended range) after the return-to-origin has been completed, follow the steps below to adjust
the machine reference value.
Step4
Place a sign indicating the robot is being adjusted.
Place a sign indicating the robot is being adjusted, to keep others from operating the controller or
operation panel.
Step5
Turn off the controller.
Step6
Enter the safety enclosure.
Step7
Put a mark at the origin position.
Scribe a mark at the current origin position on the Y-axis joint area of the robot.
At this time, be careful to prevent the origin position from deviating since the Y-axis arm is touched.
Summary of Contents for SCARA R6Y XE Series
