CHAPTER 6 USING THE COMMUNICATIONS FUNCTION
E5EK
6--10
J
Issuing special commands
Command
code
Command
code
Unit
No.
Instruction code
FCS
CR
Unit
No.
Instruction code
FCS
CR
End
code
@
@
*
*
2B
2B
4B
2B
2B
2B
2B
4B
2B
2B
2B
3
3
Command
Response
The following functions are issued as special commands.
•
Run/Reset
Runs or stops programs. This command cannot be issued in setting
level 1.
•
AT Execute/Cancel
Executes or cancels auto-tuning. This command cannot be issued in
setting level 1.
•
Move to setting level 1
Issue this command when writing parameters in the setup, expansion
and option modes. On the E5EK-T, the parameter switches to the top
parameter
“
: input type” of the setup mode, and control is
stopped.
•
Software reset
Resets E5EK-T operation (same as turning power ON) by commu-
nications. A response is not returned to this command. Also, commu-
nications with the E5EK-T cannot be carried out for five seconds after
reset.
•
Status
Monitors the status of the E5EK-T. Two command groups are avail-
able, A and B, depending on the instruction code. The response is re-
turned in bit units to the instruction code (4B) of the response frame.
For details on the monitoring details of each group, see page 6-11.
•
Hold
Holds program execution or cancels hold. This command cannot be
issued in setting level 1.
•
Advance
Advances execution of steps in the program. This command cannot be
issued in setting level 1.
00
Run/Reset
0000: Run, 0001: Reset
02
Remote/Local
0000: Local, 0001: Remote
07
AT Execute/Cancel
0000: Cancel, 0001: 40% AT execu-
tion, 0002: 100% AT execution
09
Move to setting level 1 0000
11
Software reset
0000
14
Status
0000: A group, 0001: B group
15
Hold
0000: Hold cancel, 0001: Hold
16
Advance
0000
In the case of the “Run/Reset” or “Advance” command, issue command
when the response of the previous command was returned and passed
for 0.5 seconds.
Summary of Contents for E5EK
