Omron E5EK, User Manual

Page: 196 / 203

APPENDIX
E5EK
A--14
Level 2
Setup
Expansion
Remote/Local Input type Set point upper limit
Standby time Scaling upper limit Set point lower limit
LBA detection time Scaling lower limit PID / ON/OFF
MV at reset Decimal point Operation at power ON
MV at PV error
°
C/
°
F selection End condition
MV upper limit Parameter initialize Program time unit
MV lower limit Control output 1 assignment
Step time/Rate of rise programming
MV change rate limit Control output 2 assignment Time unit of ramp rate
Input digital filter Auxiliary output 1 assignment PV start
Open/Close hysteresis Auxiliary output 2 assignment Wait width
Alarm 1 hysteresis Alarm 1 type
Alarm during ramp step enable
Alarm 2 hysteresis Alarm 1 open in alarm Run all enable
Alarm 3 hysteresis Alarm 2 type
α
Input shift upper limit Alarm 2 open in alarm AT calculated gain
Input shift lower limit Alarm 3 type
Automatic return of display mode
Alarm 3 open in alarm AT hysteresis
Direct/Reverse operation LBA detection width
Option
Calibration
Event input assignment 1 For details, refer to Chapter 7 Calibra-
tion/7 1 Structure of Parameters” (page
Event input assignment 2
tion/7.1 Structure of Parameters” (page
7-2).
Communication stop bit
Manual
Communication data length
Manual
Communication parity
Manual MV
Communication baud rate
Communication unit No.
Protect
Transfer output type
Protect
Transfer output upper limit Alarm 1 open in alarm
Transfer output lower limit Alarm 2 type
HBA latch
Motor calibration
Travel time
PV dead band