CHAPTER 5 PARAMETERS
E5EK
5--24
•
The parameters in this mode can be used only when the “security” parameter
(protect mode) is set to “0” to “2”.
•
This mode contains the auxiliary parameters for adjusting control. These parame-
ters include parameters for limiting the manipulated variable, parameters for
switching between remote and local operation, and parameters for setting the
LBA (Loop Break Alarm), alarm hysteresis, and input digital filter values.
•
To select this mode, press the
key for 1 second minimum. The display changes
to the menu display. If you select [
] pressing the
and
keys, and then
press the
key for 1 second minimum, the controller enters the level 2 mode.
•
To select parameters in this mode, press the
key. To change parameter set-
tings, use the
or
keys.
•
The following table shows the parameters supported in this mode and the page
where the parameter is described.
Symbol
Parameter Name
Page
Remote/Local
5-25
Standby time
5-25
LBA detection time
5-26
MV at reset
5-26
MV at PV error
5-26
MV upper limit
5-27
MV lower limit
5-27
MV change rate limit
5-27
Input digital filter
5-28
Open/close hysteresis
5-28
Alarm 1 hysteresis
5-29
Alarm 2 hysteresis
5-29
Alarm 3 hysteresis
5-29
Input shift upper limit
5-29
Input shift lower limit
5-29
Level 2 Mode
Summary of Contents for E5EK
