CHAPTER 5 PARAMETERS
E5EK
5--14
Pattern execution count
•
Executes the current pattern for the preset number of times.
•
The count during pattern execution can be monitored in the “pattern execution
count monitor” (level 0 mode).
Setting Range
Unit
Default
0 to 9999
Time
1
0: The pattern is not executed
F
Related description
4.4 Program Operation/Pattern operation (page 4-13)
F
Related parameters
All parameters in the program mode
Alarm value 1
Alarm value 2
Alarm value 3
Conditions of Use
Alarms must be assigned as outputs. For
example, if alarm outputs 1 and 2 only are
assigned as outputs, the “alarm value 3”
parameter cannot be used.
•
This parameter is used for monitoring or setting the alarm values of alarm out-
puts 1 to 3.
•
During temperature input, the decimal point position is dependent on the cur-
rently selected sensor, and during analog input on the results of scaling.
Setting Range
Unit
Default
-1999 to 9999
EU
0
F
Related description
3.4Setting Alarm Type (page 3-10)
3.5Setting Patterns/Alarm value (page 3-16)
F
Related parameters
“Input type” “Scaling upper limit” “Scaling lower limit” “Decimal point” “Con-
trol output 1 assignment” “Control output 2 assignment” “Auxiliary output 1
assignment” “Auxiliary output 2 assignment” “Alarm 1 type” “Alarm 2 type”
“Alarm 3 type” “Alarm 1 open in alarm” “Alarm 2 open in alarm” “Alarm 3 open
in alarm” (setup mode)
“Alarm 1 hysteresis” “Alarm 2 hysteresis” “Alarm 3 hysteresis” (level 2 mode)
Program Mode
Function
Setting
See
Function
Setting
See
Summary of Contents for E5EK
