CHAPTER 5 PARAMETERS
E5EK
5--46
•
The parameters in this mode can be used only when the “security” parameter
(protect mode) is set to “0” and “1”.
•
You can select this mode only on controllers that support optional functions. In
this mode, you can set the communications conditions, transfer output and event
input parameters to match the type of optional function supported on the control-
ler. This mode also contains the parameters for the heater burnout alarm (HBA)
function and position-proportional travel time.
•
To select this mode, press the
key for 1 second minimum. The display changes
to the menu display. If you select [
] using the
and
keys, and then
press the
key for 1 second minimum, the controller enters the option mode.
•
To select parameters in this mode, press the
key. To change parameter set-
tings, use the
or
keys.
•
The following table shows the parameters supported in this mode and the page
where the parameter is described.
Symbol
Parameter Name
Page
Event input assignment 1
5-47
Event input assignment 2
5-47
Communication stop bit
5-48
Communication data length
5-48
Communication parity
5-48
Communication baud rate
5-48
Communication unit No.
5-48
Transfer output type
5-49
Transfer output upper limit
5-49
Transfer output lower limit
5-49
HBA latch
5-50
Motor calibration
5-50
Travel time
5-51
PV dead band
5-51
Option Mode
Summary of Contents for E5EK
